Export file:

Format

  • RIS(for EndNote,Reference Manager,ProCite)
  • BibTex
  • Text

Content

  • Citation Only
  • Citation and Abstract

Optical and structural characterization of ZnSe thin film fabricated by thermal vapour deposition technique

1 Experimental Physics Division, Atomic Energy Centre, Bangladesh Atomic Energy Commission, Dhaka, Bangladesh
2 Department of Glass and Ceramic Engineering, Bangladesh University of Engineering and Technology (BUET), Dhaka, Bangladesh
3 School of Materials and Chemical Technology, Tokyo Institute of Technology, Tokyo, Japan

Topical Section: Ceramics

Zinc-selenide thin film was prepared on a soda-lime glass substrate by thermal vapor deposition technique. The X-ray diffraction data confirmed the cubic zincblende structure with a preferred orientation along (111) plane. Different models such as Debye-Scherrer, Size-Strain plot, Williamson-Hall, uniform stress deformation model and uniform deformation energy density model and the so called approximation model were adopted to analyse the XRD data. Detailed microstructural parameters such as crystallite size, strain, stress, isotropic energy density, dislocation denstiy were reported and discussed in comparison with scanning electron microscopy data. The transmission spectra was obtained by UV-Vis-NIR spectrometer in the range of 250–2500 nm at room temperature. Important optical constantssuch as refractive index and dielectric constant was estimated using Swanepoel’s envelope method. The same method was used to check the thin film thickness which was found to be ~374.9 nm and this thickness was further confirmed by Scanning Electron Microscopy (368.3 ± 19.1 nm). The optical band gap was estimated to be 2.64 eV. The dispersion of refractive index was discussed interms of empirical Cauchy dispersion relation and the dispersion was further analysed by Wemple-DiDomenico Single oscillator model which provide physically meaningful parameters such as static refractive index, oscillator energy and dispersion energy. Both the structural and optical data not only complemented each other but also implied that good quality Zinc-selenide thin film could be deposited on ordinary glass substrates.
  Figure/Table
  Supplementary
  Article Metrics

References

1. Mehta C, Saini GSS, Abbas JM, et al. (2009) Effect of deposition parameters on structural, optical and electrical properties of nanocrystalline ZnSe thin films. Appl Surf Sci 256: 608–614.    

2. Venkatachalam S, Jeyachandran YL, Sureshkumar P, et al. (2007) Characterization of vacuum-evaporated ZnSe thin films. Mater Charact 58: 794–799.

3. Xia M, Liu C, Zhao Z, et al. (2015) Formation and optical properties of ZnSe and ZnS nanocrystals in glasses. J Non-Cryst Solids 429: 79–82.    

4. Kalita PKR, Sarma BK, Das HL (2000) Structural characterization of vacuum evaporated ZnSe thin films. B Mater Sci 23: 313–317.    

5. Subbaiah YPV, Prathap P, Devika M, et al. (2005) Close-spaced evaporated ZnSe films: Preparation and characterization. Physica B 365: 240–246.    

6. Hassanien AS, Aly KA, Akl AA (2016) Study of optical properties of thermally evaporated ZnSe thin films annealed at different pulsed laser powers. J Alloy Compd 685: 733–742.

7. Lokhande CD, Patil PS, Tributsch H, et al. (1998) ZnSe thin films by chemical bath deposition method. Sol Energ Mat Sol C 55: 379–393.    

8. Sagadevan S, Das I (2016) Chemical bath deposition (CBD) of zinc selenide (ZnSe) thin films and characterisation. Aust J Mech Eng 1–6.

9. Patidar D, Rathore KS, Saxena NS, et al. (2008) Determination of optical and electrical properties of ZnSe thin films. J Mod Optic 55: 3041–3047.    

10. Mittal V, Sessions NP, Wilkinson JS, et al. (2017) Optical quality ZnSe films and low loss wave guides on Si substrates for mid-infrared. Opt Mater Express 7: 712–725.    

11. Ismail ME, Shaaban ER, Hagary ME (2016) A new method for calculating the refractive index of semiconductor thin films retrieved from their transmission spectra. J Alloy Compd 663: 20–29.    

12. Desai HN, Dhimmar JM, Modi BP (2016) Optical and dispersion analysis of Zinc Selenide thin film. Mater Today Proc 3: 1650–1657.    

13. Khan NA, Saleem A, Satti AR, et al. (2016) Post deposition annealing: a route to band gap tailoring of ZnSe thin films. J Mater Sci-Mater El 27: 9755–9760.    

14. Yuvaraj D, Kumar RR, Selvan VT, et al. (2014) Growth of ZnSe nano and microstructures at high vacuum by thermal evaporation. Appl Nanosci 4: 469–475.    

15. Lohar GM, Shinde SK, Fulari VJ (2014) Structural, morphological, optical and photoluminescent properties of spray-deposited ZnSe thin film. J Semiconduct 35: 113001.    

16. Zhang X, Wang D, Beres M, et al. (2013) Zincblende-wurtzite phase transformation of ZnSe films by pulsed laser deposition with nitrogen doping. Appl Phys Lett 103: 082111.    

17. Khanand TM, BiBi T (2012) Compatibility and optoelectronic of ZnSe nano crystalline thin film. Chinese Phys B 21: 3097303.

18. Aqili A, Ali Z, Hussain Z (2012) Optical and structural properties of silver doped ZnSe thin films prepared by CSS and ion exchange process. Thin Film Solar Technology IV, Proc. Of SPIE 8470: 84700H.

19. Khairnar U, Behere S, Pawar P (2012) Optical properties of polycrystalline Zinc Selenide thin films. Mater Sci Appl 3: 36–40.

20. Ashraf M, Akhtar SMJ, Khan AF, et al. (2011) Effect of annealing on structural and optoelectronic properties of nanostructured ZnSe thin films. J Alloy Compd 509: 2414–2419.    

21. Ismail ME, Hagary ME, Shaab ER, et al. (2012) Microstructure and optical studies of electron beam evaporated ZnSe1xTex nanocrystalline thin films. J Alloy Compd 532: 16–24.    

22. Ahamed MGSB, Nagarethinam VS, Balu AR, et al. (2010) Influence of substrate temperature on the properties of electron beam evaporated ZnSe films. Cryst Res Technol 45: 421–426.    

23. Güllü HH, Coşkun E, Parlak M (2015) Investigation of optical parameters of thermally evaporated ZnSe thin films. Phys Status Solidi C 12: 1224–1228.    

24. Kalita A, Kalita MPC (2017) Williamson-Hall analysis and optical properties of small sized ZnO nanocrystals. Physica E 92: 36–40.    

25. Kumar BR, Hymavathi B (2017) X-ray peak profile analysis of solid-state sintered alumina doped zinc oxide ceramics by Williamson-Hall and size-strain plot methods. J Asian Ceram Soc 5: 94–103.    

26. Prabhu YT, Rao KV, Kumar VSS, et al. (2014) X-Ray analysis by Williamson-Hall and size-strain slot methods of ZnO Nanoparticles with fuel variation. World J Nano Sci Eng 4: 21–28.    

27. Garg P, Rai R, Singh BK, et al. (2014) Structural characterization of "as-deposited" cesium iodide films studied by X-ray diffraction and transmission electron microscopy techniques. Nucl Instrum Meth A 736: 128–134.    

28. Monshi A, Foroughi MR, Monshi MR (2012) Modified Scherrer equation to estimate more accurately nano-crystallite size using XRD. World J Nano Sci Eng 2: 154–160.    

29. Sivasankaran S, Sivaprasad K, Narayanasamy R, et al. (2011) X-ray peak broadening analysis of AA 6061100−x–x wt.% Al2O3 nanocomposite prepared by mechanical alloying. Mater Charact 62: 661–672.

30. Zak AK, Aulmajid WH (2011) X-ray analysis of ZnO nanoparticles by Williamson-Hall and Size strain plot method. Solid State Sci 13: 251–256.    

31. Bushroa AR, Rahbari RG, Masjuki HH, et al. (2012) Approximation of crystallite size and the microstrain via XRD line broadening analysis in TiSiN thin films. Vacuum 86: 1107–1112.    

32. Ou K, Wang S, Wan G, et al. (2017) Structural, morphological and optical properties of ZnO films by thermal oxidation of ZnSe films. Thin Solid Films 634: 51–55.    

33. Nelson JB, Riley PD (1945) An experimental investigation of extrapolation methods in the derivation of accurate unit-cell dimensions of crystals. Proc Phys Soc 57: 160–177.    

34. Kim MJ, Lee SH, Kim HT, et al. (2013) Physical properties of ZnSe thin films depending on the process parameters. Mol Cryst Liq Cryst 586: 129–137.

35. Morales M, Chateigner D, Lutterotti L (2009) X-ray textural and microstructural characterizations by using the combined analysis approach for the optical optimisation of micro- and nano-structured thin films. Thin Solid Films 517: 6264–6270.    

36. Rizzoa A, Taglientea MA, Caneveb L, et al. (2000) The influence of the momentum transfer on the structural and optical properties of ZnSe thin films prepared by r.f. magnetron sputtering. Thin Solid Films 368: 8–14.    

37. Swanepoel R (1983) Determination of the thickness and optical constants of amorphous silicon. J Phys E Sci Instrum 16: 1214–1222.    

38. Dahshan A, Amer HH, Aly KA (2008) Compositional dependence of the optical constants of amorphous GexAs20Se80−x thin films. J Phys D Appl Phys 41: 215401.    

39. Aly KA (2010) Optical band gap and refractive index dispersion parameters of AsxSe70Te30−x (0 ≤ x ≤ 30 at.%) amorphous films. Appl Phys A-Mater 99: 913–919.

40. Wemple SH, DeDomenico M (1971) Behaviour of electronic dielectric constant in covalent and ionic materials. Phys Rev B 3: 1338–1351.    

41. Wemple SH, DiDomenico M (1969) Optical dispersion and the structure of solids. Phys Rev Lett 23: 1156–1160.    

42. Connell GAN, Lewis AJ (1973) Comments on the evidence for sharp and gradual optical absorption edges in amorphous germanium. Phys Status Solidi B 60: 291–298.    

43. Tauc J (1974) Amorphous and Liquid Semiconductors, New York: Plenum Publishing Corporation.

44. Venugopal B, Nandan B, Ayyachamy A, et al. (2014) Influence of manganese ions in the band gap of tin oxide nanoparticles: structure, microstructure and optical studies. RSC Adv 4: 6141–6150.    

45. Tanaka K (1980) Optical properties and photoinduced changes in amorphous AsS films. Thin Solid Films 66: 271–279.    

Copyright Info: © 2017, Md. Abdullah Zubair, et al., licensee AIMS Press. This is an open access article distributed under the terms of the Creative Commons Attribution Licese (http://creativecommons.org/licenses/by/4.0)

Download full text in PDF

Export Citation

Article outline

Show full outline
Copyright © AIMS Press All Rights Reserved