Export file:

Format

  • RIS(for EndNote,Reference Manager,ProCite)
  • BibTex
  • Text

Content

  • Citation Only
  • Citation and Abstract

The directed preparation of TiO2 nanotubes film on FTO substrate via hydrothermal method for gas sensing application

1 Faculty of Materials Science, University of Science, VNU- HCMC, 227 Nguyen Van Cu street, District 5, Ho Chi Minh City, 700000, Vietnam
2 CM Thi Laboratory - Ho Chi Minh City University of Technology (HUTECH) 475A Dien Bien Phu, Binh Thanh District, Ho Chi Minh City, 700000, Vietnam

Topical Section: Thin films, surfaces and interfaces

In this research, we directly synthesized TiO2 nanotubes film on Fluorine doped Tin oxide (FTO) substrate via hydrothermal method from commercial TiO2 in NaOH solution at 135 ℃ for 24 hours. The samples were characterized by X-ray diffraction (XRD) pattern, field emission scanning electron microscopy (FESEM) and transmitting electron microscopy (TEM). The average diameter of TiO2 nanotubes (TNTs) is about 10–12 nm and their length is about a few hundred nanometers. The sensitivity ability of TNTs increases as the gas concentration increases and developing to the highest sensitivity of TNTs is 2.4 at 700 ppm of the ethanol concentration. The same as the gas concentration, the sensitivity of TNTs increases when the temperature increases. Besides, the sensitivity of samples at 250 ℃ is doubled compared to samples determined at 100 ℃.
  Figure/Table
  Supplementary
  Article Metrics

References

1. Zhai J, Wang L, Wang D, et al. (2011) Enhancement of gas sensing properties of CdS nanowire/ZnO nanosphere composite materials at room temperature by visible-light activation. ACS Appl Mater Interface 3: 2253–2258.    

2. Zhang X, Zhang J, Jia Y, et al. (2012) TiO2 nanotube array sensor for detecting the SF6 decomposition product SO2. Sensors 12: 3302–3313.

3. Momeni MM, Ghayeb Y, Ghonchegi Z (2015) Visible light activity of sulfur-doped TiO2 nanostructure photoelectrodes prepared by single-step electrochemical anodizing process. J Solid State Electr 19: 1359–1366.    

4. Momeni MM, Ghayeb Y (2015) Fabrication, characterization and photoelectrochemical performance of chromium-sensitized titania nanotubes as efficient photoanodes for solar water splitting. J Solid State Electr 20: 683–689.

5. Momeni MM, Ghayeb Y (2015) Photochemical deposition of platinum on titanium dioxide–tungsten trioxide nanocomposites: an efficient photocatalyst under visible light irradiation. J Mater Sci 27: 1062–1069.

6. Momeni MM, Ghayeb Y (2015) Visible light-driven photoelectrochemical water splitting on ZnO–TiO2 heterogeneous nanotube photoanodes. J Appl Electr 45: 557–566.

7. Momeni MM, Ghayeb Y, Davarzadeh M (2015) Single-step electrochemical anodization for synthesis of hierarchical WO3–TiO2 nanotube arrays on titanium foil as a good photoanode for water splitting with visible light. J Electroanal Chem 739: 149–155.    

8. Momeni MM, Ghayeb Y (2015) Photoelectrochemical water splitting on chromium-doped titanium dioxide nanotube photoanodes prepared by single-step anodizing. J Alloy Compd 637: 393–400.    

9. Momeni MM, Hakimian M, Kazempour A (2015) In-situ manganese doping of TiO2 nanostructures via single-step electrochemical anodizing of titanium in an electrolyte containing potassium permanganate: A good visible-light photocatalyst. Ceram Int 41: 13692–13701.    

10. Momeni MM, Ghayeb Y (2016) Preparation of cobalt coated TiO2 and WO3–TiO2 nanotube films via photo-assisted deposition with enhanced photocatalytic activity under visible light illumination. Ceram Int 42: 7014–7022.

11. Crawford G, Chawla N, Das K, et al. (2007) Microstructure and deformation behavior of biocompatible TiO2 nanotubes on titanium substrate. Acta Biomaterialia 3: 359–367.    

12. Das K, Bose S, Bandyopadhyay A (2009) TiO2 nanotubes on Ti: Influence of nanoscale morphology on bone cell-materials interaction. J Biomed Mater Res 90A: 225–237.    

13. Kasuga T, Hiramatsu M, Hoson A, et al. (1998) Formation of Titanium Oxide Nanotube. Langmuir 14: 3160–3163.

14. Shokuhfar T, Arumugam GK, Heiden PA, et al. (2009) Direct compressive measurements of individual titanium dioxide nanotubes. ACS Nano 3: 3098–3102.    

15. Perillo PM, Rodríguez DF (2012) The gas sensing properties at room temperature of TiO2 nanotubes by anodization. Sensor Actuat B Chem 171–172: 639–643.

16. Viet PV, Phan BT, Hieu LV, et al. (2015) The Effect of Acid Treatment and Reactive Temperature on the Formation of TiO2 Nanotubes. J Nanosci Nanotechno 15: 5202–5206.    

17. Chu D, Younis A, Li S (2012) Direct growth of TiO2nanotubes on transparent substrates and their resistive switching characteristics. J Phys D Appl Phys 45: 355306.    

18. Varghese OK, Paulose M, Grimes CA (2009) Long vertically aligned titania nanotubes on transparent conducting oxide for highly efficient solar cells. Nature Nanotechno 4: 592–597.    

19. Pang Q, Leng L, Zhao L, et al. (2011) Dye sensitized solar cells using freestanding TiO2 nanotube arrays on FTO substrate as photoanode. Mater Chem Phys 125: 612–616.

20. Dmitry V Bavykin FCW (2009) Chapter 1. Introduction and Scope. RCS Nanosci Nanotechno 1–19.

21. Liu D, Liu T, Lv C, et al. (2012) Hydrothermal synthesis and gas sensing properties of different titanate nanostructures. J Mater Sci Mater El 23: 576–581.    

22. Wang YL, Tan S, Wang J, et al. (2011) The gas sensing properties of TiO2 nanotubes synthesized by hydrothermal method. Chinese Chem Lett 22: 603–606.

23. Hongsith N, Wongrat E, Kerdcharoen T, et al. (2010) Sensor response formula for sensor based on ZnO nanostructures. Sensor Actuat B Chem 144: 67–72.

24. Tian WC, Ho YH, Chen CH, et al. (2013) Sensing performance of precisely ordered TiO2 nanowire gas sensors fabricated by electron-beam lithography. Sensors 13: 865–874.

25. Al-Homoudi IA, Thakur JS, Naik R, et al. (2007) Anatase TiO2 films based CO gas sensor: Film thickness, substrate and temperature effects. Appl Surf Sci 253: 8607–8614.    

26. Yang L, Luo S, Cai Q, et al. (2010) A review on TiO2 nanotube arrays: Fabrication, properties, and sensing applications. Chinese Sci Bull 55: 331–338.

27. Liu B, Aydil ES (2009) Growth of oriented single-crystalline rutile TiO(2) nanorods on transparent conducting substrates for dye-sensitized solar cells. J Am Chem Soc 131: 3985–3990.

28. Soundarrajan P, Sankarasubramanian K, Sethuraman K, et al. (2014) Controlled (110) and (101) crystallographic plane growth of single crystalline rutile TiO2nanorods by facile low cost chemical methods. Cryst Eng Comm 16: 8756.

29. Albu SP, Ghicov A, Aldabergenova S, et al. (2008) Formation of Double-Walled TiO2Nanotubes and Robust Anatase Membranes. Adv Mater NA–NA.

30. Odair P, Ferreira AGSF, Filho JM, et al. (2006) Unveiling the Structure and Composition of Titanium Oxide Nanotubes through Ion Exchange Chemical Reactions and Thermal Decomposition Processes. J Braz Chem Soc 17: 393–402.    

31. Zhou W, Liu H, Boughton RI, et al. (2010) One-dimensional single-crystalline Ti–O based nanostructures: properties, synthesis, modifications and applications. J Mater Chem 20: 5993.    

32. Zeng W, Liu T, Wang Z (2010) UV Light Activation of TiO2-Doped SnO2 Thick Film for Sensing Ethanol at Room Temperature. Mater Trans 51: 243–245.    

Copyright Info: © 2016, Pham Van Viet, et al., licensee AIMS Press. This is an open access article distributed under the terms of the Creative Commons Attribution Licese (http://creativecommons.org/licenses/by/4.0)

Download full text in PDF

Export Citation

Article outline

Show full outline
Copyright © AIMS Press All Rights Reserved