Research article Special Issues

Experimental study on flexural behavior of concrete T-beams strengthened with externally prestressed tendons

  • Received: 15 May 2019 Accepted: 25 July 2019 Published: 30 July 2019
  • To investigate effect of the number of deviators, the tension method, and the tendon profile on the flexural behaviour of reinforcement concrete (RC) T-beams strengthened with externally prestressed tendons, seven identical RC T-beams strengthened with external prestressing tendons were tested under four-point loading. Of these, one beam was ordinary RC beam without strengthening, another six beams were classified into three groups termed G1, G2 and G3. Two beams in G1 had identical straight external tendons with a different number of deviators, two beams in G2 had identical V shape external tendons with different tension method, and two beams in G3 had identical U shape external tendons with different tension method. The failure mode, deflection, strain, load carrying capacity and ductility of the specimens under loading were recorded and analyzed. Test results indicated that strengthening with external prestressing tendons is a very effective method to improve the load carrying capacity and stiffness of the RC beam. Provision of two deviators at the loading points led to satisfactory service load behavior (deflection, cracking, and concrete strain) and a higher load carrying capacity compared to the case where one deviator or no deviators were provided. In addition, tension method of the external tendon nearly had no effect on the load carrying capacity and mechanical behaviour of the RC beams.

    Citation: Jinhua Zou, Yonghui Huang, Wenxian Feng, Yanhua Chen, Yue Huang. Experimental study on flexural behavior of concrete T-beams strengthened with externally prestressed tendons[J]. Mathematical Biosciences and Engineering, 2019, 16(6): 6962-6974. doi: 10.3934/mbe.2019349

    Related Papers:

  • To investigate effect of the number of deviators, the tension method, and the tendon profile on the flexural behaviour of reinforcement concrete (RC) T-beams strengthened with externally prestressed tendons, seven identical RC T-beams strengthened with external prestressing tendons were tested under four-point loading. Of these, one beam was ordinary RC beam without strengthening, another six beams were classified into three groups termed G1, G2 and G3. Two beams in G1 had identical straight external tendons with a different number of deviators, two beams in G2 had identical V shape external tendons with different tension method, and two beams in G3 had identical U shape external tendons with different tension method. The failure mode, deflection, strain, load carrying capacity and ductility of the specimens under loading were recorded and analyzed. Test results indicated that strengthening with external prestressing tendons is a very effective method to improve the load carrying capacity and stiffness of the RC beam. Provision of two deviators at the loading points led to satisfactory service load behavior (deflection, cracking, and concrete strain) and a higher load carrying capacity compared to the case where one deviator or no deviators were provided. In addition, tension method of the external tendon nearly had no effect on the load carrying capacity and mechanical behaviour of the RC beams.


    加载中


    [1] A. Naaman and J. Breen, External prestressing in bridges. SP-120, American Concrete Institute. Farmington Hills, MI, (1990).
    [2] A. Picard, B. Massicotte and J. Bastien, Relative efficiency of external prestressing, J. Struct. Eng., 121 (1995), 1832–1841.
    [3] N. Hakan, Strengthening structures with externally prestressed tendons-literature review, technical report, Lulea University of Technology, (2005).
    [4] H. B. Jiang, Q. Cao, A. R. Liu, et al., Flexural behavior of precast concrete segmental beams with hybrid, Constr. Build. Mater., 110 (2016), 1–7.
    [5] H. B. Jiang, Y. H. Li, A. R. Liu, et al., Shear behavior of precast concrete segmental beams with external tendons, J. Bridge Eng., 23 (2018), 04018049.
    [6] R. A. Hawileh, H. A. Rasheed, J. A. Abdalla, et al., Behavior of reinforced concrete beams strengthened with externally bonded hybrid fiber reinforced polymer systems, Mater. Design., 53 (2014), 972–982.
    [7] R. A. Hawileh, M. Z. Naser and J. A. Abdalla, Finite element simulation of reinforced concrete beams externally strengthened with short-length CFRP plates, Compos. Part B-Eng., 45 (2013), 1722–1730.
    [8] R. A. Hawileh, W. Nawaz and J. A. Abdalla, Flexural behavior of reinforced concrete beams externally strengthened with Hardwire Steel-Fiber sheets, Constr. Build. Mater., 172 (2018), 562–573.
    [9] F. M. Alkhairi and A. E. Naaman, Analysis of beams prestressed with unbonded internal or external tendons, J. Struct. Eng., 119 (1993), 2681–2700.
    [10] P. S. Rao and G. Mathew, Behavior of externally prestressed concrete beams with multiple deviators, ACI Struct. J., 93 (1996), 387–396.
    [11] T. J. Lou and Y. Q. Xiang, finite element modeling of concrete beams prestressed with external tendons. Eng. Struct., 28 (2006), 1919–1926.
    [12] B. K. Diep, H. Umehara and T. A. Tanabe, Numerical analysis of externally presressed concrete beams considering friction at deviators, J. Materials. Conc. Struct. Pavements, JSCE., 718 (2002), 107–119.
    [13] A. Zona, L. Ragni and A. Dall'Asta, Finite element formulation for geometric and material nonlinear analysis of beams prestressed with external slipping tendons, Finite Elem. Anal. Des., 44 (2008), 910–919.
    [14] A. R. C. Murthy, S. C. Ganapathi, S. Saibabu, et al., Numerical simulation of an external prestressing technique for prestressed concrete end block, Struct. Eng. Mech., 33 (2009), 605–619.
    [15] Z. C. Yang, Y. H. Huang, A. R. Liu, et al., Nonlinear in-plane buckling of fixed shallow functionally graded grapheme reinforced composite arches subjected to mechanical and thermal loading, Appl. Math. Model., 70 (2019), 315–327.
    [16] R. Z. Ai-Rousan, Shear behavior of RC beams externally strengthened and anchored with CFRP composites, Struct. Eng. Mech., 63 (2017), 447–456.
    [17] K. Tan and C. K. Ng, Effects of deviators and tendon configuration on behaviour of externally prestressed beams, ACI Struct. J., 94 (1997), 13–22.
    [18] M. Harajli, N. Khairallah and H. Nassif, Externally prestressed members: evaluation of second-order effects, J. Struct. Eng., 125 (1999), 1151–1161.
    [19] S. Matupayont, H. Mutsuyoshi, K. Tsuchida, et al., Loss of tendon's eccentricity in externally prestressed concrete beam, Transactions of the Japan Concrete Institute, 16 (1994), 1–7.
    [20] H. Mutsuyoshi, K. Tsuchida, A. Machida, et al., Flexural behavior and proposal of design equation for flexural strength of externally PC members journal of materials, concrete structures, and pavements, Japan Soc. Civil Eng., 508 (1995), 67–76.
    [21] J. L. Trinh, Structural strengthening by external prestressing, Proceedings, U.S.-European Workshop on Bridge Evaluation, Repair, and Rehabilitation, Maryland, Kluwer Academic Publishers, (1990), 513–523.
    [22] S. J. Kwon, K. H. Yang and J. H. Mun, Flexural tests on externally post-tensioned lightweight concrete beams, Eng. Struct., 164 (2018), 128–140.
  • Reader Comments
  • © 2019 the Author(s), licensee AIMS Press. This is an open access article distributed under the terms of the Creative Commons Attribution License (http://creativecommons.org/licenses/by/4.0)
通讯作者: 陈斌, bchen63@163.com
  • 1. 

    沈阳化工大学材料科学与工程学院 沈阳 110142

  1. 本站搜索
  2. 百度学术搜索
  3. 万方数据库搜索
  4. CNKI搜索

Metrics

Article views(4301) PDF downloads(625) Cited by(10)

Article outline

Figures and Tables

Figures(11)  /  Tables(4)

/

DownLoad:  Full-Size Img  PowerPoint
Return
Return

Catalog