Research article Topical Sections

Simple and effective method for evaluating performance of Si based photovoltaic cell technologies

  • Received: 29 June 2018 Accepted: 23 August 2018 Published: 29 August 2018
  • In this research, a methodology is proposed to extract temperature coefficient of open circuit voltage and intensity dependence of short circuit current of PV cells. A holistic combination of experiments and diode models of photovoltaic cells was used. The effects of light intensity and cell temperature on the performance of different solar cell technologies were investigated. Three main photovoltaic cell technologies were investigated, namely monocrystalline, polycrystalline and thin-film. The monocrystalline and polycrystalline technologies were modeled using the one-diode model whereas the thin-film technology was modeled using the two-diode model. The mean absolute bias error was close to zero for the models, which confirmed their reliability. It was observed that light intensity highly affected the current parameters while having little effect on the voltage parameters. It was also noted that cell temperature affected the voltage parameters while having minimal effect on the current parameters. The study revealed that wafer based technology exhibited higher response to irradiance and lower temperature coefficient than thin film technology. Irrespective of cell technology, temperature coefficient is linearly dependent on intensity of light.

    Citation: Yatindra K. Ramgolam, Kaviraj Bangarigadu. Simple and effective method for evaluating performance of Si based photovoltaic cell technologies[J]. AIMS Energy, 2018, 6(4): 632-644. doi: 10.3934/energy.2018.4.632

    Related Papers:

  • In this research, a methodology is proposed to extract temperature coefficient of open circuit voltage and intensity dependence of short circuit current of PV cells. A holistic combination of experiments and diode models of photovoltaic cells was used. The effects of light intensity and cell temperature on the performance of different solar cell technologies were investigated. Three main photovoltaic cell technologies were investigated, namely monocrystalline, polycrystalline and thin-film. The monocrystalline and polycrystalline technologies were modeled using the one-diode model whereas the thin-film technology was modeled using the two-diode model. The mean absolute bias error was close to zero for the models, which confirmed their reliability. It was observed that light intensity highly affected the current parameters while having little effect on the voltage parameters. It was also noted that cell temperature affected the voltage parameters while having minimal effect on the current parameters. The study revealed that wafer based technology exhibited higher response to irradiance and lower temperature coefficient than thin film technology. Irrespective of cell technology, temperature coefficient is linearly dependent on intensity of light.


    加载中
    [1] REN21 (2018) Renewables 2018 Global Status Report. Paris: REN 21 Secretariat.
    [2] Hibz YD (2014) Sarako Photovoltaic Farm Now Operational in Mauritius. Available from: http://news.islandcrisis.net/2014/02/sarako-photovoltaic-farm-now-operational-in-mauritius/.
    [3] Tradeshows & Events (2013) The first energy self sufficient car showroom in Mauritius. Available from: http://www.meeco.net/blog/the-first-energy-self-sufficient-car-showroom-in-mauritius/.
    [4] Africa, Clean Energy, Projects, Technical Solutions (2013) Solar energy at BEC schools in Mauritius. Available from: http://www.meeco.net/blog/solar-energy-at-the-bec-schools-in-mauritius/.
    [5] Fontani D, Khan P, Francini F, et al. (2015) Technique for outdoor test on concentrating photovoltaic cells. Int J Photoenergy 2015: 1–9.
    [6] Mageed H, Zobaa A, Raouf M, et al. (2010) Temperature effects on the electrical performance of large area multicrystalline silicon solar cells using the current shunt measuring technique. Engineering 2: 888–894. doi: 10.4236/eng.2010.211112
    [7] Khan F, Singh SN, Husain M (2010) Effect of illumination intensity on cell parameters of a silicon solar cell. Sol Energy Mater Sol Cells 94: 1473–1476. doi: 10.1016/j.solmat.2010.03.018
    [8] Chegaar M, Hamzaoui A, Namoda A, et al. (2013) Effect of illumination intensity on solar cells parameters. Energy Procedia 36: 722–729. doi: 10.1016/j.egypro.2013.07.084
    [9] Chander S, Purohit A, Sharma A, et al. (2015) A study on photovoltaic parameters of mono-crystalline silicon solar cell with cell temperature. Energy Rep1: 104–109.
    [10] Chander S, Purohit A, Sharma A, et al. (2015) Impact of temperature on performance of series and parallel connected mono-crystalline silicon solar cells. Energy Rep 1: 175–180.
    [11] Osterwald CR (2012) Standards, Calibration, and Testing of PV Modules and Solar Cells. National Renewable Energy Laboratory, United States.
    [12] Rustemli S, Dincer F (2011) Modeling of Photovoltaic Panel and Examining Effects of Temperature in Matlab/Simulink. Electron Electr Eng109: 1392–1215.
    [13] Said S, Massoud A, Benammar M, et al. (2012) A Matlab/Simulink-Based Photovoltaic Array Model Employing SimPowerSystems Toolbox. J Energy Power Eng6: 1965–1975.
    [14] Kessaissia FZ, Zegaoui A, Arab AH, et al. (2015) Comparison of Two PV modules Technologies Using Analytical and Experimental Methods. Energy Procedia 74: 389–397. doi: 10.1016/j.egypro.2015.07.635
    [15] Rahim NA, Ping HW, Selvaraj J, et al. (2013) Photovoltaic module modelling using Simulink/Matlab. Procedia Environ Sci 17: 537–546. doi: 10.1016/j.proenv.2013.02.069
    [16] Bellia H, Yousef R, Fatima M (2014) A detailed modeling of photovoltaic module using MATLAB. J Astron Geophys 3: 53–61.
    [17] Bouraiou A, Hamouda M, Chaker A, et al. (2015) Modeling and Simulation of Photovoltaic Module and Array based on One and Two Diode Model Using Matlab/Simulink. Energy Procedia 74: 864–877. doi: 10.1016/j.egypro.2015.07.822
    [18] Bana S, Saini RP (2016) A mathematical modelling framework to evaluate the performance of single diode and double diode based SPV systems. Energy Rep 2: 171–187. doi: 10.1016/j.egyr.2016.06.004
    [19] Duffie JA, Beckman W (2013) Solar engineering of thermal processes, 4th Edition, Wiley
    [20] Koehl M, Heck M, Wiesmeier S, et al. (2011) Modelling of the nominal operating cell temperature based on outdoor weather. Sol Energy Mater Sol Cells 95: 1638–1646. doi: 10.1016/j.solmat.2011.01.020
    [21] Skoplaki E, Boudouvis AG, Palyvos JA (2008) A simple correlation for the operating temperature of photovoltaics modules of arbitrary mounting. Sol Energy Mater Sol Cells 92: 1393–1402. doi: 10.1016/j.solmat.2008.05.016
    [22] Skoplaki E, Palyvos JA (2009) Operating temperature of photovoltaic modules: A survey of pertinent correlations. Renew Energ 34: 23–29. doi: 10.1016/j.renene.2008.04.009
  • Reader Comments
  • © 2018 the Author(s), licensee AIMS Press. This is an open access article distributed under the terms of the Creative Commons Attribution License (http://creativecommons.org/licenses/by/4.0)
通讯作者: 陈斌, bchen63@163.com
  • 1. 

    沈阳化工大学材料科学与工程学院 沈阳 110142

  1. 本站搜索
  2. 百度学术搜索
  3. 万方数据库搜索
  4. CNKI搜索

Metrics

Article views(3959) PDF downloads(989) Cited by(0)

Article outline

Figures and Tables

Figures(9)  /  Tables(2)

Other Articles By Authors

/

DownLoad:  Full-Size Img  PowerPoint
Return
Return

Catalog