Selective adsorption of fatty acid methyl esters onto a commercial molecular sieve or activated charcoal prepared from the <em>Acrocomia aculeata</em> cake remaining from press-extracting the fruit kernel oil

Sandra M. Damasceno; Vanny Ferraz; David L. Nelson; José D. Fabris; Sandra M. Damasceno; Vanny Ferraz; David L. Nelson; José D. Fabris

doi:10.3934/energy.2018.5.801

AIMS Energy

2018, Volume 6, Issue 5: 801-809. doi: 10.3934/energy.2018.5.801

Previous Article Next Article

Research article

Selective adsorption of fatty acid methyl esters onto a commercial molecular sieve or activated charcoal prepared from the Acrocomia aculeata cake remaining from press-extracting the fruit kernel oil

1.
Technology and Science Institute, Chemical Engineering Department, Federal University of the Jequitinhonha and Mucuri Valleys, Diamantina, Minas Gerais, Brazil
2.
Department of Chemistry ICEx, Federal University of Minas Gerais, Belo Horizonte, Brazil

Received: 23 July 2018 Accepted: 12 September 2018 Published: 25 September 2018

Mixing light biodiesel at low concentrations (not exceeding 5% by volume) with mineral kerosene is thought to be an interesting alternative to aviation fossil fuels without the need for engine adjustments. From the environmental point of view, this addition would mean significantly minimizing the impacts of conventional fuel emissions. The adsorption of relatively short molecular chain (C8, C10 and C12) fatty acid methyl esters (FAME), constituents of the biodiesel produced from the macaúba oil, was investigated using two types of adsorbents: A commercial molecular sieve 13X and the activated charcoal prepared from the macaúba cake remaining after press-defatting the macaúba fruit kernel. The adsorption experiments were performed on a glass column filled with the adsorbent. The activated charcoal is more efficient than the molecular sieve for selectively adsorbing FAME with C8, C10 and C12 carbon chains. The process of separating shorter chains from biodiesel by adsorption was proven to be adequate and does not compromise the energy balance. This study indicates that the charcoal obtained from the macaúba cake remaining after extracting the oil might be suitable for the selective separation of fatty acid esters, which could potentially lead to the preparation of lighter biodiesel (of lower average molecular weight) than that produced from the crude oil.
- biodiesel,
- oil,
- transesterification,
- fatty acids,
- adsorption,
- activated charcoal
Citation: Sandra M. Damasceno, Vanny Ferraz, David L. Nelson, José D. Fabris. Selective adsorption of fatty acid methyl esters onto a commercial molecular sieve or activated charcoal prepared from the Acrocomia aculeata cake remaining from press-extracting the fruit kernel oil[J]. AIMS Energy, 2018, 6(5): 801-809. doi: 10.3934/energy.2018.5.801

Related Papers:

Abstract

Mixing light biodiesel at low concentrations (not exceeding 5% by volume) with mineral kerosene is thought to be an interesting alternative to aviation fossil fuels without the need for engine adjustments. From the environmental point of view, this addition would mean significantly minimizing the impacts of conventional fuel emissions. The adsorption of relatively short molecular chain (C8, C10 and C12) fatty acid methyl esters (FAME), constituents of the biodiesel produced from the macaúba oil, was investigated using two types of adsorbents: A commercial molecular sieve 13X and the activated charcoal prepared from the macaúba cake remaining after press-defatting the macaúba fruit kernel. The adsorption experiments were performed on a glass column filled with the adsorbent. The activated charcoal is more efficient than the molecular sieve for selectively adsorbing FAME with C8, C10 and C12 carbon chains. The process of separating shorter chains from biodiesel by adsorption was proven to be adequate and does not compromise the energy balance. This study indicates that the charcoal obtained from the macaúba cake remaining after extracting the oil might be suitable for the selective separation of fatty acid esters, which could potentially lead to the preparation of lighter biodiesel (of lower average molecular weight) than that produced from the crude oil.

References

[1]	ANP-Agência Nacional do Petróleo, Gás Natural e Biocombustíveis, RESOLUÇÃO ANP Nº 63, de 05/12/2014. Available from: https://www.legisweb.com.br/legislacao/?id=278197.
[2]	ANAC-Agência Nacional de Aviação Civil. Anuário do Transporte Aéreo, volume único, 1ªedição, 2013. Available from: http://bibspi.planejamento.gov.br/bitstream/handle/iditem/628/ Anu%C3%A1rio%20do%20Transporte%20A%C3%A9reo%20de%202013.pdf?sequence=1.
[3]	IATA-International Air Transport Association (2010) Report on alternative fuels. Montreal: Iata.
[4]	Gauto MA, Apoluceno DM, Amaral MC, et al. (2016) Petróleo e Gás: Princípios de Exploração, Produção e Refino. Eds., Porto Alegre: Bookman, 246.
[5]	AIAB (2014) Inserção do Brasil nos biocombustíveis aeronáuticos. Rev da AIAB 4: 12–19.
[6]	ICAO. Why introduce alternative fuels in aviation? Available from: https://www.icao.int/environmental-protection/GFAAF/Pages/FAQs.aspx.
[7]	Wardle DA (2003) Global sale of green air travel supported using biodiesel. Renew Sust Energ Rev 7: 1–64. doi: 10.1016/S1364-0321(03)00002-9
[8]	Azami MH, Savill M (2017) Comparative study of alternative biofuels on aircraft engine performance. J Aerosp Eng 231: 1509–1521.
[9]	Llamas A, García-Martínez MJ, Al-Lal AM, et al. (2012a) Biokerosene from coconut and palm kernel oils: Production and properties of their blends with fossil kerosene. Fuel 102: 483.
[10]	Llamas A, García-Martínez MJ, Al-Lal AM, et al. (2012b) Biokerosene from babassu and camlina oils: Production and properties of their blends with fossil kerosene. Energ Fuel 26: 5968–5976.
[11]	Neuzil RW, Grove D, Rosset AJ, et al. (1977) U.S. Patent No. 4048205 Washington, DC: U.S. Patent and Trademark Office.
[12]	Cleary MT, Laughlin WC, Kulprathipanja S, et al. (1982) U.S. Patent No. 4329280 Washington, DC: U.S. Patent and Trademark Office.
[13]	Üstün G (1996) Separation of fatty acid methyl esters from tall oil by selective adsorption. J Am Oil Chem Soc 73: 203–210. doi: 10.1007/BF02523896
[14]	Alves CCO, Faustino MV, Franca AS, et al. (2015) Comparative evaluation of activated carbons prepared by thermo-chemical activation of lignocellulosic residues in fixed bed column studies. Int J Eng Tech 7: 465–469. doi: 10.7763/IJET.2015.V7.838
[15]	Duff DG, Ross MC, Vaughan H (1988) Adsorption from solution: An experiment to illustrate the Langmuir adsorption isotherm. J Chem Educ 65: 815–816. doi: 10.1021/ed065p815
[16]	Itodo AU, Abdullahi U, Grace A, et al. (2012) Performance assessment of received and formulated carbon animalis: a comparative adsorption isotherm test. J Environ Prot 3: 288–295. doi: 10.4236/jep.2012.33036
[17]	Watson JS (1999) Separation methods for waste and environmental application. Marcel Denke Inc., New York, 30–31.
[18]	Bayrak Y (2006) Application of Langmuir isotherm to saturated fatty acid adsorption. Micropor Mesopor Mat 87: 203–206. doi: 10.1016/j.micromeso.2005.08.009

Reader Comments

Your name:*

Email:*
© 2018 the Author(s), licensee AIMS Press. This is an open access article distributed under the terms of the Creative Commons Attribution License (http://creativecommons.org/licenses/by/4.0)