Research article Topical Sections

Ductile fibre reinforced cementitious composites (DFRCC) for improved corrosion durability of reinforced concrete columns

  • Received: 27 July 2017 Accepted: 24 September 2017 Published: 11 October 2017
  • This paper reports the results of an experimental program on the effectiveness of ductile fibre reinforced cementitious composites (DFRCC) in retarding the corrosion of steel, corrosion induced damage and post-corrosion structural behaviour of reinforced concrete (RC) columns. Two series RC columns are included in this program. The first series consists of ordinary RC columns that are subjected to an accelerated corrosion regime. The second series consists of two columns that are similar to first two series in every aspect, except that the ordinary concrete in the column is replaced with a ductile DFRCC material. Two types of DFRCC materials are considered: a hybrid-fibre DFRCC containing 1.5 vol.% PVA fibers and 1 vol.% steel fibers and a mono-fibre DFRCC containing 2.5 vol.% PVA fibers. Specimens of the second series are also subjected to a regime of accelerated corrosion. Corrosion damage, including the possible development of spalling and/or delamination, is monitored in each specimen using a specially-fabricated mechanical expansion collar. Based on the collective findings from theoretically-estimated steel losses, visual recordings of corrosion damage, and measurements of the tendency of cover delaminate, it was concluded that the steel reinforced DFRCC columns had a remarkably higher resistance against reinforcement corrosion compared to the ordinary RC columns. The corrosion damaged DFRCC columns also exhibited about 23–64% higher failure load than that of corrosion damaged RC columns and no sign of spalling of cover of columns in the structural test.

    Citation: Faiz Uddin Ahmed Shaikh, Mohamed Maalej, Salah Al Toubat. Ductile fibre reinforced cementitious composites (DFRCC) for improved corrosion durability of reinforced concrete columns[J]. AIMS Materials Science, 2017, 4(5): 1078-1094. doi: 10.3934/matersci.2017.5.1078

    Related Papers:

  • This paper reports the results of an experimental program on the effectiveness of ductile fibre reinforced cementitious composites (DFRCC) in retarding the corrosion of steel, corrosion induced damage and post-corrosion structural behaviour of reinforced concrete (RC) columns. Two series RC columns are included in this program. The first series consists of ordinary RC columns that are subjected to an accelerated corrosion regime. The second series consists of two columns that are similar to first two series in every aspect, except that the ordinary concrete in the column is replaced with a ductile DFRCC material. Two types of DFRCC materials are considered: a hybrid-fibre DFRCC containing 1.5 vol.% PVA fibers and 1 vol.% steel fibers and a mono-fibre DFRCC containing 2.5 vol.% PVA fibers. Specimens of the second series are also subjected to a regime of accelerated corrosion. Corrosion damage, including the possible development of spalling and/or delamination, is monitored in each specimen using a specially-fabricated mechanical expansion collar. Based on the collective findings from theoretically-estimated steel losses, visual recordings of corrosion damage, and measurements of the tendency of cover delaminate, it was concluded that the steel reinforced DFRCC columns had a remarkably higher resistance against reinforcement corrosion compared to the ordinary RC columns. The corrosion damaged DFRCC columns also exhibited about 23–64% higher failure load than that of corrosion damaged RC columns and no sign of spalling of cover of columns in the structural test.


    加载中
    [1] Bonacci JF, Maalej M (2000) Externally-bonded FRP for service-life extension of RC infrastructure. J Infrastruct Syst 6: 41–51. doi: 10.1061/(ASCE)1076-0342(2000)6:1(41)
    [2] Guo A, Li H, Ba X, et al. (2015) Experimental investigation on the cyclic performance of reinforced concrete piers with chloride-induced corrosion in marine environment. Eng Struct 105: 1–11. doi: 10.1016/j.engstruct.2015.09.031
    [3] Li X, Liang YS, Zhao ZH, et al. (2015) Low-cycle fatigue behavior of corroded and CFRP-wrapped reinforced concrete columns. Constr Build Mater 101: 902–917. doi: 10.1016/j.conbuildmat.2015.10.063
    [4] Gergely P (1981) Role of cover and bar spacing in reinforced concrete. Significant Developments in Engineering Practice and Research, SP-72, American Concrete Institute, Detroit, 72: 133–148.
    [5] Beeby AW (1978) Corrosion of reinforcing steel in concrete and its relation to cracking. Struct Eng 56: 77–81.
    [6] ACI Committee 224 (1991) Control of Cracking in Concrete Structures, ACI Manual of Concrete Practice Part 3-1991: Use of Concrete in Buildings-Design, Specifications, and Related Topics, American Concrete Institute, Detroit.
    [7] Mehta PK (1999) Advancements in concrete technology. Concrete Int 21: 69–75.
    [8] Ahmed SFU, Maalej M, Paramasivam P, et al. (2006) Assessment of corrosion-induced damage and its effect on the structural behavior of RC beams containing supplementary cementitious materials. Prog Struct Eng Mater 8: 69–77. doi: 10.1002/pse.214
    [9] Marcos-Meson V, Michel A, Solgaard A, et al. (2016) Corrosion resistance of steel fibre reinforced concrete—A literature review. Fib symposium—Performance based approaches for concrete structures.
    [10] Naaman AE (1992) High performance fibre reinforced cementitious composites, USA: E & FN Spon.
    [11] Li VC, Wu HC (1992) Condition for pseudo strain hardening in fibre reinforced brittle matrix composite. Appl Mech Rev 45: 390–398. doi: 10.1115/1.3119767
    [12] Matsumoto T, Mihashi H (2002) JCI-DFRCC summary report on DFRCC terminologies and application concept. Proceedings of JCI international workshop on ductile fibre reinforced cementitious composites, 59–66.
    [13] van Zijl GPAG, Slowik V (2017) A framework for durability design of fibre reinforced strain hardening cement based composites (SHCC). RILEM TC240-FDS.
    [14] Li VC (2003) On Engineered Cementitious Composites. J Adv Concr Technol 1: 215–230. doi: 10.3151/jact.1.215
    [15] Ahmed SFU, Mihashi H (2010) Corrosion durability of strain hardening fibre-reinforced cementitious composites. Aust J Civil Eng 8: 27–39.
    [16] Kobayashi K, Lizuka T, Kurachi H, et al. (2010) Corrosion protection performance of high performance fibre reinforced cement composites as a repair material. Cement Concrete Comp 32: 411–420. doi: 10.1016/j.cemconcomp.2010.03.005
    [17] Maalej M, Li VC (1995) Introduction of strain-hardening engineered cementitious composites in the design of reinforced concrete flexural members for improved durability. ACI Struct J 92: 167–176.
    [18] Maalej M, Ahmed SFU, Paramasivam P (2003) Corrosion durability and structural response of functionally graded concrete beams. J Adv Concr Technol 1: 307–316. doi: 10.3151/jact.1.307
    [19] Sahamaran M, Li VC, Andrade C (2008) Corrosion resistance performance of steel reinforced engineered cementitious composites beams. ACI Mater J 105: 243–250.
    [20] Miyazato S, Hiraishi Y (2005) Transport properties and steel corrosion in ductile fibre reinforced cement composites. Proceedings of the Eleventh International Conference on Fracture, 20–25.
    [21] Mihashi H, Ahmed SFU, Kobayakawa A (2011) Corrosion of reinforcing steel in fibre reinforced cementitious composites. J Adv Concr Technol 9: 159–167. doi: 10.3151/jact.9.159
    [22] Shaikh FUA, Mihashi H, Kobayakawa A (2015) Corrosion durability of reinforcing steel in cracked high performance fibre reinforced cementitious composite beams. J Mater Civil Eng 27.
    [23] Paul SC, van Zijl GPAG (2014) Crack formation and chloride induced corrosion in reinforced strain hardening cement based composite. J Adv Concr Technol 12: 340–351. doi: 10.3151/jact.12.340
    [24] Altoubat S, Maalej M, Shaikh FUA (2016) Laboratory Simulation of Corrosion Damage in Reinforced Concrete. Int J Concr Struct M 10: 383–391. doi: 10.1007/s40069-016-0138-7
    [25] Ahmed SFU, Maalej M, Paramasivam P (2007) Flexural response of hybrid steel-polyethylene fibre reinforced cement composites containing high volume fly ash. Constr Build Mater 21: 1088–1097. doi: 10.1016/j.conbuildmat.2006.01.002
    [26] Matsuoka K (1987) Monitoring of corrosion of reinforcing bar in concrete. Proceedings of the Corrosion '87 Symposium on Corrosion of Metals in Concrete, National Association of Corrosion Engineers, Houston.
    [27] Lee C, Bonacci JF, Thomas MDA, et al. (2000) Accelerated corrosion and repair of reinforced concrete columns using CFRP sheets. Can J Civil Eng 27: 941–948. doi: 10.1139/l00-030
    [28] Aiello J (1996) The effect of mechanical restraint and mix design on the rate of corrosion in concrete [Master's Thesis]. Department of Civil Engineering, University of Toronto.
    [29] Paul SC, Babafemi AJ, Coradie K, et al. (2017) Applied voltage on corrosion mass loss and cracking behavior of steel reinforced SHCC and mortar specimens. J Mater Civil Eng 29.
    [30] Solgaard AOS, Geiker M, Edvardsen C, et al. (2014) Observations on the electrical resistivity of steel fibre reinforced concrete. Mater Struct 47: 335–350.
  • Reader Comments
  • © 2017 the Author(s), licensee AIMS Press. This is an open access article distributed under the terms of the Creative Commons Attribution License (http://creativecommons.org/licenses/by/4.0)
通讯作者: 陈斌, bchen63@163.com
  • 1. 

    沈阳化工大学材料科学与工程学院 沈阳 110142

  1. 本站搜索
  2. 百度学术搜索
  3. 万方数据库搜索
  4. CNKI搜索

Metrics

Article views(4342) PDF downloads(1048) Cited by(3)

Article outline

Figures and Tables

Figures(14)  /  Tables(4)

/

DownLoad:  Full-Size Img  PowerPoint
Return
Return

Catalog