Research article Special Issues

Influence of material selection on the structural behavior of a wave energy converter

  • Received: 16 June 2014 Accepted: 23 September 2014 Published: 30 September 2014
  • In the last decades, the world energy demand has raised significantly. Concerning this fact, wave energy should be considered as a valid alternative for electricity production. Devices suitable to harness this kind of renewable energy source and convert it into electricity are not yet commercially competitive. This paper is focused on the selection and analysis of different types of elastic materials and their influence on the structural behavior of a wave energy converter (WEC). After a brief characterization of the device, a tridimensional computer aided design (3D CAD) numerical model was built and several finite element analyses (FEA) were performed through a commercial finite element code. The main components of the WEC, namely the buoy, supporting cables and hydraulic cylinder were simulated assuming different materials. The software used needs, among other parameters, the magnitude of the resultant hydrodynamic forces acting upon the floating buoy obtained from a WEC time domain simulator (TDS) which was built based on the WEC dynamic model previously developed. The Von Mises stress gradients and displacement fields determined by the FEA demonstrated that, regardless of the WEC component, the materials with low Young's modulus seems to be unsuitable for this kind of application. The same is valid for the material yield strength since materials with a higher yield strength lead to a better structural behavior of WEC components because lower stress and displacement values were obtained. The developed 3D CAD numerical model showed to be suitable to analyze different combinations of structural conditions. They could depend of different combinations of buoy position and resultant hydrodynamic forces acting upon the buoy, function of the specific sea wave parameters found on the deployment site.

    Citation: Cândida M. S. P. Malça, Pedro J. B. F. N. Beirão, Raimundo P. Felismina. Influence of material selection on the structural behavior of a wave energy converter[J]. AIMS Energy, 2014, 2(4): 359-372. doi: 10.3934/energy.2014.4.359

    Related Papers:

  • In the last decades, the world energy demand has raised significantly. Concerning this fact, wave energy should be considered as a valid alternative for electricity production. Devices suitable to harness this kind of renewable energy source and convert it into electricity are not yet commercially competitive. This paper is focused on the selection and analysis of different types of elastic materials and their influence on the structural behavior of a wave energy converter (WEC). After a brief characterization of the device, a tridimensional computer aided design (3D CAD) numerical model was built and several finite element analyses (FEA) were performed through a commercial finite element code. The main components of the WEC, namely the buoy, supporting cables and hydraulic cylinder were simulated assuming different materials. The software used needs, among other parameters, the magnitude of the resultant hydrodynamic forces acting upon the floating buoy obtained from a WEC time domain simulator (TDS) which was built based on the WEC dynamic model previously developed. The Von Mises stress gradients and displacement fields determined by the FEA demonstrated that, regardless of the WEC component, the materials with low Young's modulus seems to be unsuitable for this kind of application. The same is valid for the material yield strength since materials with a higher yield strength lead to a better structural behavior of WEC components because lower stress and displacement values were obtained. The developed 3D CAD numerical model showed to be suitable to analyze different combinations of structural conditions. They could depend of different combinations of buoy position and resultant hydrodynamic forces acting upon the buoy, function of the specific sea wave parameters found on the deployment site.


    加载中
    [1] Valério D, Beirão P, Sá da Costa J (2007) Optimisation of wave energy extraction with the Archimedes Wave Swing. Ocean Eng 34: 2330-2344. doi: 10.1016/j.oceaneng.2007.05.009
    [2] Pelc R, Fujita R (2002) Renewable energy from the ocean. Mar Policy 26: 471-479. doi: 10.1016/S0308-597X(02)00045-3
    [3] Leijon M, Danielsson O, Eriksson M, et al. (2006) An electrical approach to wave energy conversion. Renew Energy 31: 1309-1319
    [4] Boström C, Lejerskog E, Stålberg M, et al. (2008) Experimental results of rectification and filtration from an offshore wave energy system. Renew Energy 34: 1381-1387.
    [5] Beirão P, Malça C (2014) Design and analysis of buoy geometries for a wave energy converter, Int J Energy Environ Eng 5: 1-11.
    [6] Falnes J, (2002) Ocean Waves and Oscillating Systems: Linear Interactions Including Wave-Energy Extraction, 1 Eds., Cambridge: Cambridge University Press.
    [7] U.S. Army Corps of Engineers, Water Wave Mechanics Coastal Engineering Manual (EM 1110-2-1100) U.S. Army Corps Engineers, 2002. Available from: http://smos.ntou.edu.tw/CEM.htm.
    [8] Spooner E, Mueller M (2007) Comparative study of linear generators and hydraulic systems for wave energy conversion ETSU V/06/00189/REP DTI/Pub URN 01/783. University of Durham School of Engineering.
    [9] Falcão A (2010) Wave energy utilization: A review of the technologies. Renew Sustain Energy Rev 14: 899-918. doi: 10.1016/j.rser.2009.11.003
    [10] Lasa J, Antolin J, Angulo C, et al. (2012) Design, Construction and Testing of a Hydraulic Power Take-Off for Wave Energy Converters. Energies 5: 2030-2052. doi: 10.3390/en5062030
    [11] Beirão P, Malça C (2013) Hydraulic Power Take-off and Buoy Geometries Characterization for a Wave Energy Converter, Energy Power Eng 5: 72-77.
  • Reader Comments
  • © 2014 the Author(s), licensee AIMS Press. This is an open access article distributed under the terms of the Creative Commons Attribution License (http://creativecommons.org/licenses/by/4.0)
通讯作者: 陈斌, bchen63@163.com
  • 1. 

    沈阳化工大学材料科学与工程学院 沈阳 110142

  1. 本站搜索
  2. 百度学术搜索
  3. 万方数据库搜索
  4. CNKI搜索

Metrics

Article views(4810) PDF downloads(1043) Cited by(2)

Article outline

Figures and Tables

Figures(12)  /  Tables(1)

/

DownLoad:  Full-Size Img  PowerPoint
Return
Return

Catalog